- Index
- » Topic Specific Forums (COO membership required)
- » Maintenance
- » Landing Light Electrical Draw
Page:
1
Landing Light Electrical Draw
Landing Light Electrical Draw
I opertated my landing light for about an hour or so while flying. When I landed the battery didn't have enough power to start. Recharged the battery and the system is working, volt meter shows 13.5 at 1700 RPM. I will not run with the landing light on for such a long time in the future but should the landing light draw the battery down?
- Guest
- Guest
-
-
- Posts
-
Only registered users or members can reply or post
Re: Landing Light Electrical Draw
The system should be checked with the buss loaded (all electrical components on) and the voltage range should fall between 13.7 to 14.2 vdc to keep the battery properly charged. I would also check the electolyte levels in the battery.
- Guest
- Guest
-
-
- Posts
-
Only registered users or members can reply or post
Page:
1
- Index
- » Topic Specific Forums (COO membership required)
- » Maintenance
- » Landing Light Electrical Draw
Board Info
- Board Stats:
- Total Topics:
- 5972
- Total Polls:
- 1
- Total Posts:
- 16303
- Posts this week:
- 2
- User Info:
- Total Users:
- 2093
- Newest User:
- Paul Laurin
- Members Online:
- 1
- Guests Online:
- 1312
- Most Active Users:
- Director, jplaxton00, helpdesk, reecedaniel, Cessna Tech, Larry Stanford, Rick Gardner, Bob H, wrbrent, mike11003
- Online:
- carlguilliams
Forum Legend:
Topic
New
Locked
Sticky
Active
New/Active
New/Locked
New Sticky
Locked/Active
Active/Sticky
Sticky/Locked
Sticky/Active/Locked